• 
 • 
 • 
 • 
 • 
 • 
 

    Products By Manufacturer
 

 
     
 
Home About Us Products Locations Contact
 
Literature
Alignment Information
  Alignment Information
  Suggested Alignment Tolerances and Thermal Growth Differential
Balancing and Vibration
  Balancing and Vibration
  Vibration Serverity Ranges and Examples of Quality Judgement
  Single-Plane Versus Two-Plane Balancing
  Balancing Problems
  FFT Vibration Analysis
  Vibration Conversion Factors
  Vibration Identification Guide for Assembled Unit
  Vibration Constants
Slings and Wire Rope
  Slings
  Normal Sling Hitches and Lifting Capacity
  Wire Rope
  Shackles and EyeBolts
  Eyebolt Strengths
Standard Signals for Cranes
  Standard Signals for Cranes Part 1
  Standard Signals for Cranes Part 2
Units of easure And Formulas
  Motor Application, Time for Motor To Reach Operating Speed and Shaft Stress
  Temperature Conversion Table
  Metric System
  Linear Measure Metric Equivalents and Common Fractions Of An Inch
Bearings
  Locak Nuts and Lock Washers for Ball Bearings
  Lock Nuts and Lock Washers Cont'd
  Bearing Fit Tolerance Chart and Bearing Dimension Chart
  Sleeve Bearing Diametral Clearance Guide
Properties of Various Metals and Alloys
  Properties of Various Metals and Alloys
  Weight of Cold Roll Steel - Rounds
  Weight Formulas for Round and Square Steel
  Properties of Various Metals and Alloys Cont'd
Bolts and Nuts
  Common Bolt Grade Markings
  Common Bolt Grade Markings Cont'd
  Torque Requirements For Bolted Joints
  Bolt Tightening Torque Values
  Tap Drills and Clearance for Machine Screws
Lubrication
  Lubircation
  Amount of Grease Required When Regreasing Motor Bearings
Key and Key Ways
  Keys and Key Ways
  Nema Motor Frame Standard Key Sizes and Key Ways
  Nema Motor Frame Standard Key Sizes and Key Ways Cont'd
  Nema Motor Frame Standard Key Sizes and Key Ways Cont'd
  IEC Motor Frame Standard Key Ways
Welding, Brazing And Soldering
  Welding, Brazing and Soldering
  Joint Designs for Electroslag Welding
  Joint Designs for Electroslag Welding Cont'd
  Soldering
  Flux Requirements For Metals, Alloys and Coatings
Belts and Sheaves
  Pulley Formulas
  Belt Installation
  Mounting Pulleys, Sheaves, Sprockets and Gears
  Belt Tensioning
  Belt Deflection Force and Elongation Ratio
  Standard "V" Belt Profiles
  Sheave Dimensions
  V-Belt Sheave Dimensions
 
Home - About Us - Products - Locations - Literature - Calculations - Services - Privacy Policy - Contact

Site Designed and Developed By: JeremySelph.com